Comprehensive kits
Apr 6, 2015 19:06:43 GMT
Post by MarkH on Apr 6, 2015 19:06:43 GMT
(This kit is no longer available.)
I am now offering a comprehensive kit that contains almost everything you need to build either a GPS+ or Autopilot+ panel. The introductory cost is £112 plus shipping. Shipping to mainland UK will be £5.50. You can order by contacting me here.
Kit contents
- Laser-cut acrylic panels.
- All components.
- Leo Bodnar BBI-32 controller board with spring connectors (solderless).
- Approximately 30m of connecting wire (colour-coded).
- Heat-shrink tubing (optional).
- Cable ties.
- 4mm machine screws + nuts (x2).
- 4mm x 30mm wood screws (x6).
- 4mm (M8) cup washers (x6).
- Comprehensive assembly and setup instructions (by email - if you have the eBook you don't need this).
What you will need to do
- Print your own graphics from the templates provided here (or your own design) on an inkjet or laser printer.
- Cut the wires into 50cm lengths and connect them to the components. Ideally you should solder the connections but you can do it solderless by just using heat-shrink.
- Assemble the panel.
- Decide how you want to mount the panel and the BBI-32 board.
Here is a picture of a kit ready to go:
I am now offering a comprehensive kit that contains almost everything you need to build either a GPS+ or Autopilot+ panel. The introductory cost is £112 plus shipping. Shipping to mainland UK will be £5.50. You can order by contacting me here.
Kit contents
- Laser-cut acrylic panels.
- All components.
- Leo Bodnar BBI-32 controller board with spring connectors (solderless).
- Approximately 30m of connecting wire (colour-coded).
- Heat-shrink tubing (optional).
- Cable ties.
- 4mm machine screws + nuts (x2).
- 4mm x 30mm wood screws (x6).
- 4mm (M8) cup washers (x6).
- Comprehensive assembly and setup instructions (by email - if you have the eBook you don't need this).
What you will need to do
- Print your own graphics from the templates provided here (or your own design) on an inkjet or laser printer.
- Cut the wires into 50cm lengths and connect them to the components. Ideally you should solder the connections but you can do it solderless by just using heat-shrink.
- Assemble the panel.
- Decide how you want to mount the panel and the BBI-32 board.
Here is a picture of a kit ready to go:
