|
Post by rogo2022 on May 11, 2022 20:32:41 GMT
Hi Mark, I'm moving on to my second panel and hope you don't mind me asking for a bit of help. Before drilling more holes I want to experiment with my Bodnar board. If I use their software to assign a rotary encoder can I change this later. I suspect there isn't a problem but... Also the button switches for the AP - I propose using latching switches - would that be right? I'd appreciate your thoughts.
Regards, Roger
|
|
|
Post by MarkH on May 11, 2022 22:15:40 GMT
Hi Mark, I'm moving on to my second panel and hope you don't mind me asking for a bit of help. Before drilling more holes I want to experiment with my Bodnar board. If I use their software to assign a rotary encoder can I change this later. I suspect there isn't a problem but... Also the button switches for the AP - I propose using latching switches - would that be right? You can change the rotary encoder assignments at will, so don't worry about experimenting. As for the switches, you do not need latching ones for the AP. All the AP functions work on momentary button presses. You could use latching switches if you wanted, but you would need to program duplicate assignments to the ON and OFF actions.
|
|
|
Post by rogo2022 on May 12, 2022 10:49:51 GMT
Thanks Mark, that's very helpful. Fun isn't it?
|
|
|
Post by MarkH on May 12, 2022 16:26:25 GMT
Thanks Mark, that's very helpful. Fun isn't it? More fun than flying, it often turns out
|
|